Letter disks to replace the original letter disks in each knob. This is just the Letter "Cl" for the Cigarette Lighter
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "H" for the heater fan switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "L" for the Light Switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "W" for the Wiper Switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Replacement glass for the Datsun 320 rear view mirror.
Note: These should be glued into place using a neutral cure or non acid cure silicone
These shims come in 3 different thicknesses and are required to set the bearing preload and axle float on the rear axles.
This is a second hand item in good condition
Front tension rod for the Datsun 320 utility, 320 wagon and 320 Dual cab - Sold as a set of 8
Front Outer Upper suspension bush for the Datsun 320 utility, 320 wagon and 320 Dual cab - Sold as a set of 4
Front swaybar link rubbers for the Datsun 320 utility, 320 wagon and 320 Dual cab - Sold as a set of 8
Sway Bar Bushing Suspension Stabilizer Bar Bushing Kit to suit Datsin 320. Made from polyurethane.
Sold as a set of 2
These are reproduction red and amber tail light lens to suit the Datsun 320, Sold as a set of 4
Wheel stud suit both front and rear axles on Datsun 320
This is a second hand item in very good condition
This insulating washer fits between the fuel pump and the engine block to reduce heat transfer from the block into the fuel pump.
This is a second hand item in working order
Hot Box Gasket to suit the Datsun E1 Engine as used in Datsun 320. This gasket fits between the inlet manifold and the exhaust manifold
Manifold Gasket to suit the Datsun E1 Engine as used in the Datsun 320 range.
Water Pump Gasket to suit the Datsun E1 Engine as used in Datsun 320 range.
These are reproduction red and amber tail light lens to suit the Datsun N320
Reproduction 3D printed tailgate bumper rubber. These attach to the body with 2 small screws inside the tailgate opening. They are only fitted to the N320 variant
Note: If your located in the USA please contact Moses Thompson directly for these items.
