This kit consists of 4 rubber grommets and 1 circlip. There are 3 small grommets used to mount the motor and one large dust shield grommet to go around the drive shaft housing. I have also included a circlip to replace the one-time use circlip that holds the wiper connecting arm onto the crank.
Plastic replacement lids with a modern seal and breather system. Much easier to get off than a rusty original. Sold as a pair, suits both the Brake Master Cylinder and the Clutch Master Cylinder.
Clutch slave cylinder push rod for column change cars (not sure if it fits the floor change vehicles)
As my own Datsun 320 restoration project progresses along no doubt I'll discover more bits that are hard or impossible to find. I also keep an eye on social media to see what parts others are looking for as well.
| Weather Strips | Negotiating to get a few 100m of the door belt or weather strip for the doors made. | |
| Rear Tail Lights | Re-production of the tail light lens for the N320, NL320 and U320 is under way. hopefully these NLA parts will arrive soon | |
| Engine Mounts | Having obtained 2 NOS mounts i'm looking for someone to reproduce them. The first quote that came back was a bit too expensive. I'm still on the hunt for an alternative manufacturer. | |
| King Pin Kits | 20 sets of King pin kits are on thier way from the manufacturer. Each kit inludes 2 x kinpins, 4 x bushes, 2 x bearings, 2 x cotterpins and a selection of shims. I expect them here early 2021 |
Clutch Release Bearing.
Complete VRS Gaskey set for the Datsun E1 Engine.
This is an aftermarket replacement fuel filter made by RYCO Australia, It comes with a new spring
This pressure plate suits cars fitted with the column change transmission
Leaf Spring bush for the front mount for the Datsun 320 utility, 320 wagon and 320 Dual cab - Sold as a set of 2
As my own Datsun 320 restoration project progresses along no doubt I'll discover more bits that are hard or impossible to find. I also keep an eye on social media to see what parts others are looking for as well.
| Weather Strips | Negotiating to get a few 100m of the door belt or weather strip for the doors made. | |
| Rear Tail Lights | Re-production of the tail light lens for the N320, NL320 and U320 is under way. hopefully these NLA parts will arrive soon | |
| Engine Mounts | Having obtained 2 NOS mounts i'm looking for someone to reproduce them. The first quote that came back was a bit too expensive. I'm still on the hunt for an alternative manufacturer. | |
| King Pin Kits | 20 sets of King pin kits are on thier way from the manufacturer. Each kit inludes 2 x kinpins, 4 x bushes, 2 x bearings, 2 x cotterpins and a selection of shims. I expect them here early 2021 |