Letter disks to replace the original letter disks in each knob. This is just the Letter "H" for the heater fan switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "C" for the Choke Knob
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "W" for the Wiper Switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "L" for the Light Switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
This is a replacement lens only for the rear reflector. sold as a pair.
Fitting this lens is not an easy task, it will require some patience.
Replacement glass for the Datsun 320 rear view mirror.
Note: These should be glued into place using a neutral cure or non acid cure silicone
Reproduction 3D printed tailgate bumper rubber. These attach to the body with 2 small screws inside the tailgate opening. They are only fitted to the N320 variant
Note: If your located in the USA please contact Moses Thompson directly for these items.
Reproduction rubber door bumper rubbers that screw onto the "B" pillar - Sold as a pair
Most of the 320 hinges I've seen have been badly worn. Those that do feel nice and firm have more that likely split the hinge pin into 2 or 3 pieces and that firm action comes from them grinding on the end of the broken pin. New pins are easy to find but getting the old pins out can be very difficult.
Reproduction spear shaped side marker lens only to suit Datsun B10 1000 - Sold as a pair
These are the shorter version of this lens that are approximately 94mm long
EW 7049
As my own Datsun 320 restoration project progresses along no doubt I'll discover more bits that are hard or impossible to find. I also keep an eye on social media to see what parts others are looking for as well.
| Weather Strips | Negotiating to get a few 100m of the door belt or weather strip for the doors made. | |
| Rear Tail Lights | Re-production of the tail light lens for the N320, NL320 and U320 is under way. hopefully these NLA parts will arrive soon | |
| Engine Mounts | Having obtained 2 NOS mounts i'm looking for someone to reproduce them. The first quote that came back was a bit too expensive. I'm still on the hunt for an alternative manufacturer. | |
| King Pin Kits | 20 sets of King pin kits are on thier way from the manufacturer. Each kit inludes 2 x kinpins, 4 x bushes, 2 x bearings, 2 x cotterpins and a selection of shims. I expect them here early 2021 |