This kit consists of one nut (used), one washer (used) and one split pin (new), enough for one side of the car.
This is a second hand item in very good condition
Second hand fuse block (no cover)
Letter disks to replace the original letter disks in each knob. This is just the Letter "Cl" for the Cigarette Lighter
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "H" for the heater fan switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "C" for the Choke Knob
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "W" for the Wiper Switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "L" for the Light Switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
This is a replacement lens only for the rear reflector. sold as a pair.
Fitting this lens is not an easy task, it will require some patience.
Replacement glass for the Datsun 320 rear view mirror.
Note: These should be glued into place using a neutral cure or non acid cure silicone
Reproduction 3D printed tailgate bumper rubber. These attach to the body with 2 small screws inside the tailgate opening. They are only fitted to the N320 variant
Note: If your located in the USA please contact Moses Thompson directly for these items.